Installation/Set-Up Challenges for Metric Pipework Low Integrity Compression Systems

Common installation or setup challenges when using Metric Pipework Low Integrity Compression Systems may include:

1. Tightening: Ensuring proper tightening of compression fittings is crucial; overtightening can cause damage to the fittings and pipes, while undertightening can lead to leaks.

2. Pipe Preparation: Inadequate preparation of the pipe ends can result in leaks. Properly cutting and deburring the pipe ends is essential for a secure connection.

3. Alignment: Incorrect alignment of pipes during installation can cause stress on the fittings and lead to leaks over time. Ensuring proper alignment is crucial for a reliable connection.

4. Use of Correct Tools: Using the correct tools for installation, such as pipe cutters, deburring tools, and appropriate wrenches, is essential to ensure a proper setup and avoid damage to the fittings.

5. Pipe Condition: Installing compression fittings on damaged or corroded pipes can lead to leaks. It is important to inspect the condition of the pipes and replace any damaged sections before installation.

6. Threaded Components: If using compression fittings with threaded components, ensuring proper threading and sealing with thread sealant is important to prevent leaks.

7. System Design: Incorrect system design, such as using the wrong fittings or not accounting for pressure and temperature requirements, can result in system failures. Ensuring the system design meets the specific requirements is essential.

By addressing these challenges and following manufacturer guidelines and best practices, you can ensure a successful installation of Metric Pipework Low Integrity Compression Systems.